Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi EA50 — Toshiba e-Studio 307

Code: EA50

Description: Stapling jam: Stapling is not performed properly. [MJ-1032/MJ-1033]
Causes: MJ-1101 Finisher controller PC board
Remedy: MJ-1101 Finisher • Check if there is any paper in the finisher or on the transport path of the equipment or on the finishing tray. Remove it if there is. • Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple sheet slid from the staple case? • Check if the actuator of the stapler interference sensor (S11) moves smoothly. • Check if the connector CN2 on the finisher controller PC board is disconnected from the stapler or the harnesses are open circuited. Correct if any. • Check the harnesses in the stapler are disconnected or open circuited. Correct if any.
MJ-1032 Staple unit stapling start position sensor (S17) abnormality Measure the voltage on TP23 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when the sensor is ON and within the range of 3.3V ± 5% when OFF. If the voltage does not fall within the range mentioned, replace the staple unit. Staple unit staple empty sensor (S18) abnormality Measure the voltage on TP24 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when the sensor is ON and within the range of 3.3V ± 5% when OFF. If the voltage does not fall within the range mentioned, replace the staple unit. Faulty cables and connectors Check if the electrical continuity between the connector terminals is normal. If electricity is not conducted, replace the connectors. (Finisher control PC board (FIN): CN17) Finisher control PC board (FIN) abnormality If the error still occurs after replacing the staple unit and the connectors, exchange the finisher control PC board (FIN).

← Xem tất cả mã lỗi Toshiba e-Studio 307

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie