Code: EAB0
Description: Paper transport jam in Saddle Stitch Finisher: Paper transport jam in Saddle Stitch Finisher [MJ-1106]
Causes: MJ-1106 Junction box paper detection sensor (S26) Feeding sensor (S22) Transport path-2 (S27) Transport path-3 (S28) Ejecting roller (S29) Entrance motor (M1) Transport path switching solenoid (SOL9) Interface PC board (I/F) Saddle stitcher controller board Finisher controller board
Remedy: MJ-1106 Paper Do not use the paper longer than the specification. Transport roller Fix any mechanical problem occurring when the transfer roller is rotated. Feeding sensor (S22) • Sensor check(S22) • Connector check • Harness check Junction box paper detection sensor (S26) • Sensor check(S26) • Connector check(CN8) • Harness check Transport path-2 (S27) • Sensor check(S27) • Connector check(CN20) • Harness check Transport path-3 (S28) • Sensor check(S28) • Connector check(CN20) • Harness check Ejecting roller sensor(S29) • Sensor check(S29) • Connector check(CN20) • Harness check Transport path switching solenoid (SOL5) Check that the gap between the transfer guide surface and the upper surface of the flapper tip is in the acceptable range according to the status of the transport path switching solenoid (SOL5) (solenoid OFF: 1.5 to 2.1 mm, solenoid ON: 2.3 to 2.9 mm). If it is not, adjust it. Entrance motor (M1) • Motor check(M1) • Connector check(CN26) • Harness check Transport path switching solenoid (SOL9) • Solenoid check(SOL9) • Connector check(CN26) • Harness check Interface PC board (I/F) • Board check • Connector check(CN1, CN2, CN5, CN7, CN8) • Harness check Saddle stitcher controller board • Board check • Connector check(CN10, CN13, CN20) • Harness check
MJ-1033 Transport motor-2 (M2) abnormality Check if the electrical continuity of the coil is normal. If electricity is not conducted, replace the motor. Saddle stitch entrance path sensor (S4) abnormality Measure the voltage on TP2 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when not shielded and within the range of 3.3V±5% when shielded. If the voltage does not fall within the range mentioned, replace the sensor. Faulty cables and connectors Check if the electrical continuity between the connector terminals is normal. If electricity is not conducted, replace the connectors. (Finisher control PC board (FIN): CN13, CN1) Finisher control PC board (FIN) abnormality If the error still occurs after replacing the motor, sensor and connectors, exchange the finisher control PC board (FIN).
MJ-1033 Transport motor-2 (M2) abnormality Check if the electrical continuity of the coil is normal. If electricity is not conducted, replace the motor. Saddle stitch entrance path sensor (S4) abnormality Measure the voltage on TP2 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when not shielded and within the range of 3.3V±5% when shielded. If the voltage does not fall within the range mentioned, replace the sensor. Faulty cables and connectors Check if the electrical continuity between the connector terminals is normal. If electricity is not conducted, replace the connectors. (Finisher control PC board (FIN): CN13, CN1) Finisher control PC board (FIN) abnormality If the error still occurs after replacing the motor, sensor and connectors, exchange the finisher control PC board (FIN).