Code: C9E
Description: IMC board connection abnormal
Remedy: Is "Call for service" displayed again even after the copier is turned OFF and then back ON? N: Observe the condition for a while. Y: 1. Check if the IMC board, SYS board and the IMG board are firmly connected to the MTH1 board. 2. Check if the connector J181, J182, J185 or J188 on the IMC board is disconnected. 3. Check if the connector J161 on the IMG board is disconnected. 4. Check if the connector J1 on the SCM board is disconnected. 5. Check if the harness connected to the IMC board is open- or short-circuited or if any connector pin is disconnected. 6. Check if the harness between the SCM and IMG boards is open-circuited or if any connector pin is disconnected. 7. If this problem recurs frequently, replace the IMC board.