Code: CA00
Description: color registration abnormality
Causes:
Remedy: 1 <Color toner low density> Check the printing status. Is the color printing ratio 5% or more? Yes 2 No The color toner low density might be the cause. Turn the code 08-2692 "Prevention of color toner low density / ON/OFF setting" to ON, and then set number of sheets to be judged at the code 08- 2693 "Prevention of color toner low density/Judged number of sheets setting". 2 Open the front cover and take off the exit tray. (Refer to "4.1.2 Exit Tray".) 3 Take off toner cartridges (Y) and (M), and then close the front cover. 4 Perform color registration pattern / image quality control pattern.Is an image created on the transfer belt? Yes 8 No 5 5 Check if there is any abnormality on the hand grips and rods of the main charger cleaner. Correct if there is. 6 Check if the drum is rotated properly by turning the coupling of the developer unit. Correct the auger and the surrounding hardware if not. 7 Laser optical unit • Check the connectors and harnesses between the LGC board (CN343, CN355, and CN356) and the laser optical unit. • Check if there is any stain or scratch on the glass surface of the laser optical unit. Clean or correct if there is. 8 Check if there is any stain on the image quality sensor and Image position aligning sensors. 9 Check if the sensor shutter is working properly. 10 < Invalidating color registration control > • Turn the power ON while [0] and [8] are pressed simultaneously. • Key in “4546”, then press the [START] button. (08-4546: Position adjustment control / Mode setting) • Set the value to “0” (not performed automatically). • Turn the power OFF. 11 < Checking the abnormal status on color registration > • Turn the power ON while [0] and [5] are pressed simultaneously. • Key in “4720”, then press the [START] button. (05-4720: Displaying the cause of color registration detection error)