Code: E010
Description: Jam not reaching the exit sensor: The paper which has passed through the fuser unit does not reach the exit sensor.
Causes: Exit sensor LGC board Registration roller clutch Registration roller
Remedy: 1 Open the Automatic duplexing unit. Is there any paper on the transport path? Yes Remove the paper. No 2 2 Is the exit sensor working? (Perform the input check in the test mode: FS-03- [ALL]OFF/[9]/[C]) Yes 3 No • Check if the connector of the exit sensor is disconnected. • Check if the connector CN308 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the exit sensor • Replace the LGC board 3 Is the registration roller clutch working? (Perform the output check in the test mode: FS-03- 108/158) Yes 4 No • Check if the connector of the registration roller clutch is disconnected. • Check if the connector CN318 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the registration roller clutch. • Replace the LGC board. 4 Registration roller • Check the registration roller. Replace it if it is worn out.