Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E130 — Toshiba e-Studio 3508AG

Code: E130

Description: 1st drawer misfeeding (Paper not reaching the 1st transport sensor): The paper fed from the 1st drawer does not reach the 1st transport sensor.
Causes: 1st transport sensor. LGC board 1st drawer feed clutch 1st drawer feed roller 1st drawer separation roller 1st drawer pickup roller
Remedy: 1 Open the Automatic duplexing unit. Is there any paper in front of the 1st transport sensor? Yes Remove the paper. No 2 2 Is the 1st transport sensor working? (Perform the input check in the test mode: FS-03- [ALL]OFF/[9]/[B]) Yes 3 No • Check if the connector of the 1st transport sensor is disconnected. (J661, J659) • Check if the connector CN318 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the 1st transport sensor. • Replace the LGC board. 3 Is the 1st drawer feed clutch working? (Perform the output check in the test mode: FS-03- 201) Yes 4 No • Check if the connector of the 1st drawer feed clutch is disconnected. (J666) • Check if the connector CN316 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the 1st drawer feed clutch. • Replace the LGC board. 4 1st drawer feed roller Separation roller Pickup roller • Check the 1st drawer feed roller, separation roller and pickup roller. Replace them if they are worn out.

← Xem tất cả mã lỗi Toshiba e-Studio 3508AG

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie