Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi CC30 — Toshiba e-Studio 3511

Code: CC30

Description: Stack processing motor abnormality: The stack processing motor is not rotating or the stack delivery belt is not moving normally. [MJ-1022]
Remedy: MJ-1022 [Procedure 1] Is the tension of the drive belt normal? NO Loosen the adjustment screw to adjust its tension. YES Does the bushing attached to the returning roller shaft smoothly move up and down? NO Apply grease on the cut-out part of the front side frame with where the bushing contacts. YES Is the spring of the returning roller detached? YES Attach the spring. NO Is the wiring between the finisher controller PC board and stack processing motor (M2) correct? NO Correct the wiring. YES Is the stack delivery lever home position sensor (S8) working properly? NO Replace the sensor. YES 1. Replacing the stack processing motor. 2. Replace the finisher controller PC board. [Procedure 2] Does the bushing attached to the returning roller shaft smoothly move up and down? NO Apply grease on the cut-out part of the front side frame with where the bushing contacts. YES Is the spring of the returning roller detached? YES Attach the spring. NO Is the tension of the stack processing motor drive belt normal? NO Loosen the adjustment screw to adjust its tension. YES Is the returning roller home position sensor (S3) working properly? NO Replace the sensor. YES 1. Replace the stack processing motor. 2. Replace the finisher controller PC board.

← Xem tất cả mã lỗi Toshiba e-Studio 3511

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie