Code: CEE1
Description: Transfer belt position detection abnormality (when decelerating): Reference position of the transfer belt cannot be detected.
Remedy: If the error [CEE0] has occurred, check the transfer belt home position sensor-1. If the error [CEE1] has occurred, check the transfer belt home position sensor-2. Is there any stain or scratch on the reflection tape inside the transfer belt? YES Clean the transfer belt or replace it. Replace the cleaning pad if it is excessively stained. NO Are the transfer belt home position sensors-1 and -2 stained? YES Clean them. NO Are the transfer belt home position sensors-1 and -2 working properly? (Perform the input check: 03-[FAX]ON/[9]/[H]) NO 1. Check if the connectors or joint connectors of the transfer belt home position sensors-1 and -2 are disconnected. 2. Check if the connector CN361 on the LGC board is disconnected. 3. Check if the connector pins are disconnected or the wires of harnesses are opencircuited. 4. Check if the conductor pattern on the LGC board is short- or open-circuited. 5. Replace the transfer belt home position sensor-1 and -2. 6. Replace the LGC board. YES 1. Check if the conductor pattern on the LGC board is short- or open-circuited. 2. Replace the LGC board.