Description: Jam not reaching the reverse sensor (during scanning): The original which passed the read sensor does not reach the reverse sensor when it is transported from the scanning section to reverse section.
Remedy: Is the read roller stained? YES Clean the roller. NO Are the exit sensor and reverse sensor working? (Perform the input check: 03-[FAX]ON/[7]/[E], [7]/[F]) NO 1. Check if the connectors of the exit sensor and reverse sensor are disconnected. 2. Check if the connector CN4 on the RADF board is disconnected. 3. Check if the connector pins are disconnected or the harnesses are open-circuited. 4. Check if the conductor pattern on the RADF board is short- or open-circuited. 5. Replace the exit sensor and reverse sensor. 6. Replace the RADF board. YES Replace the RADF board.