Code: EAB0
Description: Transport stop jam: The paper which passed through the inlet sensor does not reach or pass No.1 paper sensor, No. 2 paper sensor, No.3 paper sensor or delivery
Remedy: MJ-1024 Is there any paper remaining on the transport path in the finisher, saddle stitcher section or equipment? YES Remove the paper. NO Is the connector J708 on finisher controller PC board disconnected? Is the harness between the finisher controller PC board and inlet sensor [PI33] open-circuited? Is either of the connectors J9 or J10 on the saddle stitcher controller PC board disconnected? Is the harness between the saddle stitcher controller PC board and each sensor (No.1 paper sensor [PI18], No.2 paper sensor [PI19], No.3 paper sensor [PI20] and the delivery sensor [PI11]) open-circuited? YES Connect the connectors securely. Replace the harnesses. NO Is each of the sensors (the inlet sensor, No.1 paper sensor, No.2 paper sensor, No.3 paper sensor and the delivery sensor) working properly? (Check the movement of the actuator.) NO 1. Connect the connectors of the sensors securely. 2. Attach the actuators securely if their shafts are out of place. 3. Replace the sensors. YES Replace the saddle stitcher controller PC board.