Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E220 — Toshiba e-Studio 351c

Code: E220

Description: 2nd drawer transport jam (Paper not reaching the 1st drawer feed sensor): The paper does not reach the 1st drawer feed sensor after it has passed the 2nd drawer feed sensor.
Remedy: Open the jam access cover. Is there paper in front of the upper drawer feed sensor? → YES → Remove the paper. NO Is the upper drawer feed sensor working? (Perform the input check: 03-[FAX]ON/[3]/[H]) ↓→ NO → 1) Check if the connector of the upper drawer feed sensor is disconnected. 2) Check if the connector CN338 on the LGC board is disconnected. 3) Check if the connector pins are disconnected or the harnesses are open circuited. 4) Check if the conductor pattern on the LGC board is short circuited or open circuited. 5) Replace the upper drawer feed sensor. 6) Replace the LGC board. YES Are the lower transport clutches (high/low speed) working? (Perform the output check: 03-203, 205) ↓→ NO → 1) Check if the connectors of the lower transport clutches (high/low speed) are disconnected. 2) Check if the connector CN341 on the LGC board is disconnected. 3) Check if the connector pins are disconnected or the harnesses are open circuited. 4) Check if the conductor pattern on the LGC board is short circuited or open circuited. 5) Replace the lower transport clutches (high/low speed). 6) Replace the LGC board. YES 1) Check the condition of the feed roller, separation roller and pickup roller of each paper source, and replace them if they are worn out. 2) Check the transport roller. Replace it if it is worn out.

← Xem tất cả mã lỗi Toshiba e-Studio 351c

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie