Description: Stop jam at the original exit/reverse sensor: The trailing edge of the original does not pass the original exit/reverse sensor after its leading edge has reached this sensor.
Remedy: Is the exit roller stained? → YES → Clean the roller. NO Is the exit sensor working? (Perform the input check: 03-[FAX]ON/[7]/[E]) ↓→ NO → 1) Check if the connector of the exit sensor is disconnected. 2) Check if the connector CN75 on the RADF board is disconnected. 3) Check if the connector pins are disconnected or the harnesses are open circuited. 4) Check if the conductor pattern on the RADF board is short circuited or open circuited. 5) Replace the exit sensor. 6) Replace the RADF board. YES Replace the RADF board.