Description: Transport delay jam: The paper which has reached the inlet sensor does not pass through the inlet sensor. [MJ-1024]
Remedy: MJ-1024 Is there any paper remaining on the transport path in the finisher, saddle stitcher section or equipment? YES Remove the paper. NO Is the connector J708 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and inlet sensor (PI33) open-circuited? YES Connect the connector securely. Replace the harness. NO Is the inlet sensor working properly? (Check the movement of the actuator.) NO 1. Connect the connector of the sensor securely. 2. Attach the actuator securely if its shaft is out of place. 3. Replace the sensor. YES Replace the finisher controller PC board.