Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi C468 — Toshiba e-Studio 3520c

Code: C468

Description: Pressure roller thermistor abnormality after entering ready status (overheating)
Causes: Power supply unit LGC board
Remedy: Pressure roller thermistor • Connector check • Check if the pressure roller center/rear thermistor is installed properly. • Check if the harnesses of the pressure roller center and rear thermistors are open circuited. Power supply unit and fuser unit • Check if the fuser unit is installed properly. • Check if the pressure roller lamp is open circuited. (Check if the pressure roller lamp has electric continuity.) • Check if the connector of the pressure roller lamp is disconnected. • Check if the thermistor is open circuited. • Check if the connectors of the power supply (CN404, CN405, CN408, CN409) are disconnected. • Check if the power supply unit is broken. LGC board • Connector check (CN333, CN345, CN361) • Check if the conductor pattern on the board is short circuited or open circuited. Status counter Change the current status counter value (08-2002) "5", "6", "8", "18", "20", "26", "28", "33" or "34" to "0" • The status counter value is set as follows in the following cases. • The error occurred during warming-up: "5" or "6" • The error occurred after the equipment has become ready: "33" • Regardless of the equipment’s status (i.e. during warmingup, printing, paper jam or in ready status), when the temperature detected by the pressure roller thermistor is 210°C or higher: "8", "18", "20", "26" or "28". • The error occurred during printing: "34"

← Xem tất cả mã lỗi Toshiba e-Studio 3520c

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie