Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi CB50 — Toshiba e-Studio 355

Code: CB50

Description: Staple motor (staple/fold) abnormality: The staple motor is not rotating normally or the stapler is not moving normally. [MJ-1025] Staple motor abnormality: Staple motor is not rotating or stapler is not moving normally. [MJ-1024] Staple unit abnormality: Staple unit is not moving normally. [MJ-1031] Stapler home position error: The stapler home position sensor does not work. [MJ-1101]
Remedy: MJ-1025 [Procedure 1] Is the wiring between the finisher controller PC board and the staple/fold motor normal? NO Correct the wiring. YES Try to rotate the staple jam releasing dial. Is there mechanical trapping? YES Fix the mechanism. NO Try replacing the staple/fold motor (M7). Is the problem corrected? YES End. NO Replace the finisher controller PC board. [Procedure 2] Is the staple/fold motor clock sensor (PI14) working properly? NO Replace the sensor. YES Does the staple/fold motor operate at the appropriate timing? YES Replace the finisher controller PC board. NO Is the stapler unit drive mechanism working properly? NO Fix the mechanism. YES Try replacing the staple/fold motor (M7). Is the problem corrected? YES End. NO Replace the finisher controller PC board. [Procedure 3] Is the folding home position sensor (PI11) working properly? NO Replace the sensor. YES Is the wiring between the finisher controller PC board and the staple/fold motor normal? NO Correct the wiring. YES Try to rotate the fold jam releasing dial. Is there mechanical trapping? YES Fix the mechanism. NO Try replacing the staple/fold motor (M7). Is the problem corrected? YES End. NO Replace the finisher controller PC board. [Procedure 4] Is the staple/fold motor clock sensor (PI14) working properly? NO Replace the sensor. YES Does the staple/fold motor operate at the appropriate timing? YES Replace the finisher controller PC board. NO Is the saddle stitch unit drive mechanism working properly? NO Fix the mechanism. YES Try replacing the staple/fold motor (M7). Is the problem corrected? YES End. NO Replace the finisher controller PC board.
MJ-1024 Is the wiring between the stapler and finisher controller PC board correct? NO Correct the wiring. YES 1. Replace the stapler. 2. Replace the finisher controller PC board.
MJ-1031 1. Check if the connectors J112, J113 on the finisher controller PC board is disconnected from the stapler) or the harnesses are open circuited. Correct if any. 2. Replace the staple unit. 3. Replace the finisher control PC board.
* You receive a [CB50] error when the [EA50] error occurs three times in succession. MJ-1101 Is the harness between the stapler and the finisher control PC board (CN2) disconnected or open circuited? l ..YES • Reconnect the connector securely. • Replace the harness. NO Are the harnesses in the stapler disconnected or open circuited? l ..YES • Reconnect the connector securely. • Replace the harness. NO Replace the finisher control PC board.

← Xem tất cả mã lỗi Toshiba e-Studio 355

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie