Description: Jam not reaching the exit sensor (during scanning): The original which passed the read sensor does not reach the exit sensor when it is transported from the scanning section to exit section.
Remedy: 1. Clean the read roller if it is stained. 2. Is the original exit/reverse sensor working? (Perform the input check: 03-[FAX]ON/[7]/[E]) * If it is working properly, proceed to 6. If not, check 3 to 5 below. 3. Check if the connector CN75 on the RADF board is disconnected from the original exit/reverse sensor or the harnesses are open circuited. Correct if any. 4. Replace the original exit/reverse sensor 5. Replace the RADF board. 6. Replace the read roller if it is worn out.