Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi EAC0 — Toshiba e-Studio 355

Code: EAC0

Description: Saddle transport delay jam: The paper which has reached the inlet sensor does not pass through this sensor. [MJ-1025/MJ-1024]
Remedy: MJ-1025 Is there any paper remaining on the paper transport path in the saddle stitcher section in the finisher? YES Remove the paper. NO Is the connector CN16 (folding position sensor) on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and folding position sensor opencircuited? YES Connect the connector securely. Replace the harness. NO Is the folding position sensor working properly? NO Replace the sensor. YES Replace the finisher controller PC board.
MJ-1024 1. Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the equipment. Remove it if there is. 2. Is the connector J21 on saddle stitcher controller PC board disconnected? 3. Is the harness between the saddle stitcher controller PC board and saddle inlet sensor [PI22] open circuited? 4. Is the saddle inlet sensor working properly? (Check the movement of the actuator.) 5. Replace the sensor. 6. Replace the saddle stitcher controller PC board.

← Xem tất cả mã lỗi Toshiba e-Studio 355

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie