Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi EA60 — Toshiba e-Studio 3555C

Code: EA60

Description: Early arrival jam: The entrance path sensor detects the paper earlier than a specified timing. [MJ-1036] Early arrival jam: The entrance sensor detects the paper earlier than a specified timing. [MJ- 1107] Early arrival jam: The feed sensor detects the paper earlier than a specified timing. [MJ-1108]
Causes: MJ-1107 Entrance sensor Finisher controller PC board
MJ-1108 Feeding sensor (S22) Interface control PC board (I/F)
Remedy: MJ-1036 Entrance path sensor (S19) abnormality Measure the voltage on TP86 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when not shielded and within the range of 3.3V±5% when shielded. If the voltage does not fall within the range mentioned, replace the sensor. Faulty cables and connectors Check if the electrical continuity between the connector terminals is normal. If electricity is not conducted, replace the connector. (Finisher control PC board (FIN): CN22) Finisher control PC board (FIN) abnormality If the error still occurs after replacing the sensor and the connector, exchange the finisher control PC board (FIN).
MJ-1107 Entrance sensor • Sensor check(S1) • Connector check (CN7) • Harness check Finisher controller PC board • Board check • Connector check (CN7) • Harness check
MJ-1108 Finisher Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. Feeding sensor (S22) • Sensor check(S22) • Connector check (CN8) • Harness check Interface control PC board (I/F) • Board check • Connector check (CN8) • Harness check

← Xem tất cả mã lỗi Toshiba e-Studio 3555C

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie