Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E011 — Toshiba e-Studio 3555CSE

Code: E011

Description: Transfer belt paper-clinging jam: The paper after the 2nd transfer is clinging to the transfer belt.
Causes: Process unit Registration motor DRV board LGC board Paper clinging detection sensor Registration roller
Remedy: Paper jamming immediately after the removal and installation of the transfer belt unit. Transfer belt unit Check if the transfer belt unit is installed properly. "4.7.3 Transfer belt unit (TBU)" Paper stop jam at transfer belt Drawer Check if paper is folded at the leading edge. No scratches on the paper leading edge Drawer Check if paper is folded at the leading edge. Check that paper is not skewed in the side guides of the drawer. Process unit Clean the process unit or replace it. Paper clinging detection sensor Clean the sensor All DRV board . Board check . Connector check (CN461, CN450, CN451) . Harness check LGC board . Board check . Connector check (CN361, CN362) . Harness check Paper clinging detection sensor . Sensor check (Perform the input check: 03- [ALL]OFF/[9]/[E]) . Connector check (J643, J645, J1109, CN461) . Harness check Check of the 2nd transfer roller connection Check that the 2nd transfer roller shaft is securely grounded via the frame. . Check if the leaf spring is deformed. . Check if the shaft tip and the leaf spring contact properly. Change of the 2nd transfer bias If the leading edge of paper clings to the 2nd transfer roller and causes paper jamming, change the 2nd transfer roller bias correction factor of the leading/trailing edge of the paper. (The larger the value, the smaller the transfer voltage of the leading/trailing edge of the paper.) Codes to be changed (Initial value of the transfer bias of the leading edge of the paper: 0) . Color mode print (top side): 05-2938-* . Color mode print (back side): 05-2939-* . Black mode print (top side): 05-2940-* . Black mode print (back side): 05-2941-* Sub codes:* → Plain paper: 0, Thick paper 1: 1, Thick paper 2: 2, Thick paper 3: 3, Overhead transparencies: 4, Special paper 1: 5, Special paper 2: 6, Recycled paper: 7, Thick paper 4: 8, Thin paper: 9, Envelope: 10, Special paper 3: 11 Notes: After these codes are changed, perform solid duplex-printing and check that there is no faint or void image on the leading/trailing

← Xem tất cả mã lỗi Toshiba e-Studio 3555CSE

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie