Code: E130
Description: Upper drawer misfeeding (Paper not reaching the 1st transport sensor): The paper fed from the upper drawer does not reach the 1st transport sensor.
Causes: 1st transport sensor. LGC board Upper drawer feed clutch Upper drawer feed roller Separation roller Pickup roller
Remedy: 1 Open the Automatic duplexing unit. Is there any paper in front of the 1st transport sensor? Yes Remove the paper. No 2 2 Is the 1st transport sensor working? (Perform the input check in the test mode: 03- [FAX]OFF/[6]/[A]) Yes 3 No • Check if the connector of the 1st transport sensor is disconnected. • Check if the connector CN316 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the 1st transport sensor. • Replace the LGC board. 3 Is the upper drawer feed clutch working? (Perform the output check in the test mode: 03-201) Yes 4 No • Check if the connector of the upper drawer feed clutch is disconnected. • Check if the connector CN315 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the upper drawer feed clutch. • Replace the LGC board. 4 Upper drawer feed roller Separation roller • Check the upper drawer feed roller, separation roller and pickup roller. Replace them if they are worn out.