Remedy: 1. Turn the power OFF and start up the Setting Mode (08). 2. When "SRAM REQUIRES INITIALIZATION" is displayed on the LCD, check the destination and then press the [START] button. If the destination is not correct, key in the correct one and then press the [START] button. 3. After the confirmation message is displayed on the LCD, press the [INTERRUPT] button (to initialize the SRAM). 4. Perform the panel calibration (08-9050). 5. Perform the initialization after the software version upgrade (08-9030). 6. Enter the serial number (08-9601). Be sure that the serial number is the same as that on the identification label attached on the rear cover of the equipment. 7. Initialize the NIC information (08-9083). 8. Turn the power OFF and then start up with the Adjustment mode (05). 9. Perform "Data transfer of characteristic value of scanner" (05-3203). 10.Turn the power OFF and then back ON. If the error is not recovered, replace the SRAM on the SYS board.