Code: 981
Description: Belt Up/Down Sensor Error
Remedy: 1 Is the engine code the latest level? Go to step 2. Update the printer with latest code level. If this does not resolve the problem, continue with step 2. 2 Are connectors CN409 and CN407 on the sensor board connected properly? Go to step 3. Plug the connectors in securely. 3 Are connectors CN11 on the CK1 daughter board, and CN15, CN3, CN4, and CN5 on the printer controller board connected properly? Go to step 4. Properly connect all connections. 4 Remove the transfer belt. Verify the belt up/down sensor actuator flag, on the bottom of the transfer belt unit is properly installed, not broken, and in the proper position. Rotate the shaft attached to the belt up/down sensor actuator flag. Are there any binds other than when engaging the transfer belt? Make sure the sensor is fully snapped in place, and that the sensor connector is fully seated. Are these items correct? Go to step 5. If the sensor is out of position or disconnected, properly install the sensor and properly connect the sensor to the belt unit. If the shaft attached to the belt up/down sensor actuator binds, replace the transfer belt unit. If the sensor actuator flag is broken, replace the transfer belt unit. 5 Clean the belt up/down sensor (located on the bottom of the transfer belt unit). Does this fix the problem? Problem solved. Go to step 6. 6 Disconnect the belt up/down sensor on the transfer belt unit, bypassing the density sensor and door open sensor. Power on the printer. Does the belt up/down shaft rotate during POST? Replace the transfer belt unit. Go to step 7. 7 Replace the transfer belt unit. Did this fix the problem? Problem solved. Replace the printer controller board.