Description: Jam not reaching the reverse sensor (during reverse feeding): The leading edge of the original does not reach the reverse sensor when original is fed from the reverse section.
Remedy: Is the reverse roller stained? YES Clean the roller. NO Is the reverse sensor working? (Perform the input check: 03-[FAX]ON/[7]/[F]) NO 1. Check if the connector of the reverse sensor is disconnected. 2. Check if the connector CN4 on the RADF board is disconnected. 3. Check if the connector pins are disconnected or the harnesses are opencircuited. 4. Check if the conductor pattern on the RADF board is short- or open-circuited. 5. Replace the reverse sensor. 6. Replace the RADF board. YES Replace the RADF board.