Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi EA30 — Toshiba e-Studio 450

Code: EA30

Description: Power-ON jam: Paper exists at the inlet sensor when power is turned ON. [MJ-1022/1025]
Remedy: MJ-1022 Is there any paper remaining on the transport path in the finisher? YES Remove the paper. NO Is the connector J10 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and inlet sensor (S2) open-circuited? YES Connect the connector securely. Replace the harness. NO Is the inlet sensor working properly? (Check the movement of the actuator.) NO 1. Connect the connector of the inlet sensor securely. 2. Attach the actuator securely if its shaft is out of place. 3. Replace the inlet sensor. YES Replace the finisher controller PC board.
MJ-1023/1024 Is there any paper remaining on the transport path in the finisher? YES Remove the paper. NO Is any of the connectors J707, J708 and J722B on the finisher controller PC board disconnected? Is the harness between the finisher controller PC board and each sensor (the inlet sensor [PI33], transport path sensor [PI34] and the processing tray sensor [PI38]) open-circuited? YES Connect the connectors securely. Replace the harnesses. NO Is each of the sensors (the inlet sensor, transport path sensor and processing tray sensor) working properly? (Check the movement of the actuator.) NO 1. Connect the connectors of the sensors securely. 2. Attach the actuators securely if their shafts are out of place. 3. Replace the sensors. YES Replace the finisher controller PC board.

← Xem tất cả mã lỗi Toshiba e-Studio 450

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie