Code: EA40
Description: Door open jam: The finisher has been released from the equipment during printing. [MJ-1022/1025]
Remedy: MJ-1022 Is there any paper remaining on the transport path in the finisher or equipment? YES Remove the paper. NO Is the finisher connected with the equipment? NO Connect the finisher with the equipment. YES Is the connector J11 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and joint sensor (S4) open-circuited? YES Connect the connector securely. Replace the harness. NO Is the joint sensor working properly? NO 1. Connect the connector of the joint sensor securely. 2. Replace the joint sensor. YES Replace the finisher controller PC board.
MJ-1023/1024 Is there any paper remaining on the transport path in the finisher or equipment? YES Remove the paper. NO Is either of the covers upper and front of the finisher closed? NO Close the cover. YES Is any connectors J707 and J708 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and upper and front cover opening sensors(PI31 and PI32) open-circuited? YES Connect the connector securely. Replace the harness. NO Is the upper/front cover opening sensor working properly? NO 1. Connect the connector of the upper/front cover opening sensor securely. 2. Replace the upper/front cover opening sensor. YES Is the connector J719 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and front cover switch (MS31) open-circuited? YES Connect the connector securely. Replace the harness. NO Is the front cover switch working properly? NO 1. Connect the connector of the front cover switch securely. 2. Replace the front cover switch. YES Is the connector J5 on the punch controller PC board disconnected? Is the harness connecting the punch controller PC board and upper door switch (MSW61) open-circuited? Is the harness connecting the punch controller PC board and front door switch (MSW62) open-circuited? YES Connect the connector securely. Replace the harness. NO Are the upper and front door switches working properly? NO 1. Connect the connectors of the upper and front door switches securely. 2. Replace the upper/front door switches. YES Replace the finisher controller PC board.
MJ-1023/1024 Is there any paper remaining on the transport path in the finisher or equipment? YES Remove the paper. NO Is either of the covers upper and front of the finisher closed? NO Close the cover. YES Is any connectors J707 and J708 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and upper and front cover opening sensors(PI31 and PI32) open-circuited? YES Connect the connector securely. Replace the harness. NO Is the upper/front cover opening sensor working properly? NO 1. Connect the connector of the upper/front cover opening sensor securely. 2. Replace the upper/front cover opening sensor. YES Is the connector J719 on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and front cover switch (MS31) open-circuited? YES Connect the connector securely. Replace the harness. NO Is the front cover switch working properly? NO 1. Connect the connector of the front cover switch securely. 2. Replace the front cover switch. YES Is the connector J5 on the punch controller PC board disconnected? Is the harness connecting the punch controller PC board and upper door switch (MSW61) open-circuited? Is the harness connecting the punch controller PC board and front door switch (MSW62) open-circuited? YES Connect the connector securely. Replace the harness. NO Are the upper and front door switches working properly? NO 1. Connect the connectors of the upper and front door switches securely. 2. Replace the upper/front door switches. YES Replace the finisher controller PC board.