Code: EAA0
Description: [MJ-1110] Paper remaining jam in the saddle stitch unit
Causes: Junction box paper detection sensor (S26) Transport path-2 sensor (S27) Transport path-3 sensor (S28) Ejecting roller sensor (S29) Finisher control PC board (FIN) Saddle control PC board (SDL)
Remedy: Paper • Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the equipment. Remove it if there is. • Use paper accepted in the specifications. Do not use the paper shorter than the specification. Junction box paper detection sensor (S26) • Sensor check(S26) • Connector check(CN1) • Harness check Transport path-2 sensor (S27) • Sensor check(S27) • Connector check(CN3) • Harness check Transport path-3 sensor (S28) • Sensor check(S28) • Connector check(CN3) • Harness check Ejecting roller sensor(S29) • Sensor check(S29) • Connector check(CN3) • Harness check Harness Check if the flat cable between the finisher control PC board (FIN) and the saddle control PC board (SDL) is disconnected or open circuited. Correct if so. (Replace the harness if open circuited. Reconnect the connector securely if there is any disconnection.) Finisher control PC board (FIN) • Board check • Connector check(CN21) • Harness check Saddle control PC board (SDL) • Board check • Connector check(CN3, CN6) • Harness check