Code: E140
Description: 2nd drawer misfeeding (Paper not reaching the 2nd transport sensor): The paper fed from the 2nd drawer does not reach the 2nd transport sensor.
Causes: 2nd transport sensor LGC board 2nd drawer feed clutch 2nd drawer feed roller 2nd drawer separation roller 2nd drawer pickup roller
Remedy: 1 Open the feed cover. Is there any paper in front of the 2nd transport sensor? Yes Remove the paper. No 2 2 Is the 2nd transport sensor working? (Perform the input check in the test mode: FS-03- [F3]ON/[4]/[D]) Yes 3 No • Check if the connector of the 2nd transport sensor is disconnected. (J676) • Check if the connector CN318 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the 2nd transport sensor. • Replace the LGC board. 3 Is the 2nd drawer feed clutch working? (Perform the output check in the test mode: FS-03- 202) Yes 4 No • Check if the connector of the 2nd drawer feed clutch is disconnected. • Check if the connector CN316 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the 2nd drawer feed clutch. • Replace the LGC board. 4 2nd drawer feed roller Separation roller Pickup roller • Check the 2nd drawer feed roller, separation roller and pickup roller. Replace them if they are worn out.