Code: EA25
Description: Paper transport jam in the Finisher (after paper stack exit): Paper is detected in the finishing tray sensor after the paper stack has exited from the finishing tray. [MJ-1042] Paper transport jam (after paper stack exit): The finishing tray paper detection sensor detects paper after a stack of paper exits from the finishing tray. [MJ-1109/1110]
Causes: Finishing tray paper detection sensor (S12) Finisher control PC board (FIN)
Remedy: MJ-1042 Stack exit motor (M5) abnormality Check if the electrical continuity of the coil is normal. If electricity is not conducted, replace the motor. Faulty cables and connectors Check if the electrical continuity between the connector terminals is normal. If electricity is not conducted, replace the connectors. (Finisher control PC board (FIN): CN14) Finisher control PC board (FIN) abnormality If the error still occurs after replacing the motor, sensor and connectors, exchange the finisher control PC board (FIN).
MJ-1109/MJ-1110 Paper Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. Finishing tray paper detection sensor (S12) • Sensor check • Connector check (CN25) • Harness check Finisher control PC board (FIN) • Board check • Connector check (CN25) • Harness check
MJ-1109/MJ-1110 Paper Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. Finishing tray paper detection sensor (S12) • Sensor check • Connector check (CN25) • Harness check Finisher control PC board (FIN) • Board check • Connector check (CN25) • Harness check