Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E030 — Toshiba e-Studio 4508AG

Code: E030

Description: Power-ON jam: The paper is remaining on the paper transport path when power is turned ON.
Causes: Sensor. LGC board
Remedy: 1 Open the cover of the unit/ area whose picture is blinking on the control panel. Is there any paper on the transport path? (Refer to the following table.) Yes Remove the paper. No 2 2 Is the sensor in the jamming area working? (Perform the input check in the test mode: refer to the following table.) Yes 3 No • Check if the connector of the sensor is disconnected. • Check if any of the connectors on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the sensor • Replace the LGC board. 3 LGC board • Replace the LGC board.
Registration area Automatic duplexing unit Registration sensor FS-03-[ALL]OFF/[9]/[A] 1st transport sensor FS-03-[ALL]OFF/[9]/[B] Exit area Automatic duplexing unit Exit sensor FS-03-[ALL]OFF/[9]/[C] ADU ADU ADU entrance sensor FS-03-[ALL]OFF/[9]/[G] ADU exit sensor FS-03-[ALL]OFF/[9]/[H] Feeding area (Main unit) Feed cover 2nd transport sensor FS-03-[F3]ON/[4]/[D] LCF LCF side cover LCF feed sensor FS-03-[F1]ON/[9]/[F] PFP PFP side cover PFP upper drawer feed sensor FS-03-[F3]ON/[0]/[C] PFP lower drawer feed sensor FS-03-[F3]ON/[0]/[D] Bridge unit Bridge unit Bridge unit transport sensor-1 FS-03-[ALL]OFF/[0]/[A] Bridge unit transport sensor-2 FS-03-[ALL]OFF/[0]/[B] JSP JSP cover JSP feed sensor FS-03-[ALL]OFF/[0]/[A]

← Xem tất cả mã lỗi Toshiba e-Studio 4508AG

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie