Code: EA60
Description: Early arrival jam: A paper jam occurs because paper from the equipment arrives at the Finisher too early. [MJ-1042/1109/1110]
Causes: Feeding sensor (S22) Finisher controller PC board (FIN)
Remedy: MJ-1042 Entrance path sensor (S19) abnormality Measure the voltage on TP86 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when not shielded and within the range of 3.3V+-5% when shielded. If the voltage does not fall within the range mentioned, replace the sensor. Faulty cables and connectors Check if the electrical continuity between the connector terminals is normal. If electricity is not conducted, replace the connector. (Finisher control PC board (FIN): CN22) Finisher control PC board (FIN) abnormality If the error still occurs after replacing the sensor and the connector, exchange the finisher control PC board (FIN).
MJ-1109/1110 Paper Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. Feeding sensor (S22) • Sensor check(S22) • Connector check (CN1) • Harness check Finisher controller PC board (FIN) • Board check • Connector check (CN1) • Harness check
MJ-1109/1110 Paper Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. Feeding sensor (S22) • Sensor check(S22) • Connector check (CN1) • Harness check Finisher controller PC board (FIN) • Board check • Connector check (CN1) • Harness check