Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 843 — Toshiba e-Studio 450S

Code: 843

Description: Service Scanner
Causes: This error indicates that a problems has been detected with the flatbed carriage mechanical hardware. It may also indicate interference between the flatbed CCD assembly and a metal bracket.
Remedy: 1 Flatbed scanner CCD drive shafts Check to make sure that both of the CCD drive shafts are correctly installed. If correct, go to step 2. 2 Flatbed CCD module assembly ribbon cable Check to make sure that the flatbed CCD module assembly is connected correctly to both the CCD module and J2 on the scanner control card. If correct, go to step 3. 3 Flatbed CCD module assembly Check the flatbed CCD assembly for any signs of damage and for proper mechanical operation. If any problems are found, replace the flatbed CCD assembly. If the flatbed CCD assembly is replaced, it is necessary to perform scanner registration. See “Scanner registration”. 4 Flatbed CCD scan motor/ cable Flatbed interface card Check for correct installation of the CCD scan motor cable to both the motor and to the flatbed interface card at CN2. Enter the Diagnostics Menu (turn on MFP while holding 3 and 6), select SCANNER TESTS, and select Feed Tests.If the motor does not turn during the scanner Feed Test, check for any signs of binds or mechanical problems. Repair as necessary. If no problem is found, go to step 5. 5 Flatbed home sensor cable Flatbed home sensor Flatbed interface card Check to make sure that the home sensor cable is correctly installed to both the home sensor and to CN4 on the flatbed interface card. Check for correct operation of the home sensor. If it does not operate correctly, replace the FRUs in the following order: • Flatbed interface card. See “Flatbed interconnect card removal”. • Flatbed home sensor. See “Home sensor removal”. If the problem persists, go to step 6. 6 Mechanical interference with the flatbed CCD assembly Check for mechanical interference with the flatbed CCD assembly and the metal locating bracket. Remove the glass slit. See “Scanner flatbed glass holder assembly removal”. The bracket is located near the home position, to the left side of the flatbed. 1. Move the flatbed CCD assembly a few inches to the right of home. 2. Bend the bracket upwards 1–2 mm. 3. Move the flatbed CCD assembly back to the home position and check for clearnace between the bracket and the edge of the flatbed CCD assembly. If this does not fix the problem, got to step 7. 7 Flatbed scanner assembly If the 843.00 error code continues to be displayed, replace the complete flatbed scanner assembly. See “Flatbed scan assembly removal”. Note: If the flatbed scanner assembly is replaced, it is necessary to perform scanner registration. See “Scanner registration”.

← Xem tất cả mã lỗi Toshiba e-Studio 450S

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie