Description: Thermistor abnormality during printing: Abnormality of the thermistor is detected during printing.
Remedy: 1. Check the front edge thermistor (1) Check if the connector is disconnected. (2) Check if the front edge thermistor is in contact with the surface of the fuser belt properly. (3) Check if the harness of the front edge thermistor is open-circuited. 2. Check the LGC board (1) Check if the connector CN358 is disconnected. (2) Check if the conductor pattern on the board is short- or open-circuited. (3) Replace the LGC board. 3. Clear the status counter Change the current status counter value (08-400) “6” to “0”.