Description: Revolver home position detection abnormality: It cannot detect that the revolver is at its home position.
Remedy: Is the revolver home position sensor working properly? (Perform the input check: 03-[FAX]ON/[2]/[C]) NO 1. Check if the connector or joint connector of the revolver home position sensor is disconnected. 2. Check if the connector CN361 on the LGC board is disconnected. 3. Check if the connector pins are disconnected or the wires of harnesses are open-circuited. 4. Check if the conductor pattern on the LGC board is short- or open-circuited. 5. Replace the revolver home position sensor. 6. Replace the LGC board. YES 1. Check if the conductor pattern on the LGC board is short- or open-circuited. 2. Replace the LGC board.