Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E550 — Toshiba e-Studio 4511

Code: E550

Description: Paper remaining jam on the transport path: The paper is remaining on the transport path when printing is finished (caused by a multiple paper feeding).
Remedy: Open the cover of the unit/area whose picture is flashing on the control panel. Is there any paper on the transport path? YES Remove the paper. NO Is the sensor in the jamming area working? (Perform the input check: Refer to the following table) NO 1. Check if the connector of the sensor is disconnected. 2. Check if any of the connectors on the LGC board is disconnected. 3. Check if the connector pins are disconnected or the harnesses are open-circuited. 4. Check if the conductor pattern on the LGC board is short- or open-circuited. 5. Replace the sensor. 6. Replace the LGC board. YES Replace the LGC board.
Registration area Exit area ADU Bypass unit Feeding area (equipment) LCF PFP Bridge unit Finisher Test Mode/Input check 03-[FAX]ON/[9]/[E] 03-[FAX]ON/[3]/[H] 03-[FAX]OFF/[7]/[H] 03-[FAX]OFF/[8]/[H] 03-[FAX]OFF/[8]/[G] 03-[FAX]ON/[9]/[D] 03-[FAX]ON/[3]/[G] 03-[FAX]OFF/[5]/[G] 03-[FAX]OFF/[2]/[D] 03-[FAX]OFF/[4]/[D] 03-[FAX]ON/[0]/[C] 03-[FAX]ON/[0]/[A] - Cover Jam access cover Fuser cover ADU Bypass unit Side cover LCF side cover PFP side cover Bridge unit Finisher door Sensor Registration sensor Upper drawer feed sensor Exit sensor ADU entrance sensor ADU exit sensor Bypass feed sensor Lower drawer feed sensor LCF feed sensor PFP upper drawer feed sensor PFP lower drawer feed sensor Bridge unit transport sensor-1 Bridge unit transport sensor-2 Sensors in the finisher

← Xem tất cả mã lỗi Toshiba e-Studio 4511

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie