Code: CC30
Description: Stack processing motor abnormality: The stack processing motor is not rotating or the stack delivery belt is not moving normally. [MJ-1022]
Remedy: MJ-1022 [Procedure 1] Is the tension of the drive belt normal? NO Loosen the adjustment screw to adjust its tension. YES Does the bushing attached to the returning roller shaft smoothly move up and down? NO Apply grease on the cut-out part of the front side frame where the bushing contacts. YES Is the spring of the returning roller detached? YES Attach the spring. NO Is the wiring between the finisher controller PC board and stack delivery motor (M2) correct? NO Correct the wiring. YES Is the stack delivery lever home position sensor (S8) working properly? NO Replace the sensor. YES 1. Replacing the stack processing motor. 2. Replace the finisher controller PC board. [Procedure 2] Does the bushing attached to the returning roller shaft smoothly move up and down? NO Apply grease on the cut-out part of the front side frame where the bushing contacts. YES Is the spring of the returning roller detached? YES Attach the spring. NO Is the tension of the stack processing motor drive belt normal? NO Loosen the adjustment screw to adjust its tension. YES Is the returning roller home position sensor (S3) working properly? NO Replace the sensor. YES 1. Replace the stack delivery motor. 2. Replace the finisher controller PC board.