Code: CC80
Description: Alignment motor (front) abnormality: The alignment motor (front) is not rotating normally or the front alignment plate is not moving normally. Front aligning plate motor abnormality: Front aligning plate motor is not rotating or aligning plate is not moving normally. [MJ-1024] Rear alignment motor abnormality: The rear alignment motor is not rotating or the rear alignment plate is not moving normally. [MJ-1101]
Remedy: MJ-1025 (Alignment motor (front) abnormality) Is the aligning plate home position sensor (front) (PI4) working properly? NO Replace the sensor. YES Is the wiring between the finisher controller PC board and alignment motor (front) (M4) correct? NO Correct the wiring. YES Is there any mechanical problem with the path of aligning plate? YES Fix the mechanism. NO Try replacing the alignment motor (front) (M4). Is the problem corrected? YES End. NO Replace the finisher controller PC board.
MJ-1024 (Front aligning plate motor abnormality) Is the front aligning plate home position sensor (PI36) normal? NO Replace the sensor. YES Is the wiring between the finisher controller PC board and the front aligning plate motor (M33) correct? NO Correct the wiring. YES Is there any mechanical problem with the path of aligning plate? NO Fix the mechanism. YES 1. Replace the front aligning plate motor. 2. Replace the finisher controller PC board.
MJ-1101 Is there any mechanical problem when the rear alignment plate is moved? ..YES Fix the mechanism. NO Is the harness between the rear alignment motor (M10) and the finisher control PC board (CN10) disconnected or open circuited? l ..YES • Reconnect the connector securely. • Replace the harness. NO 1. Replace the rear alignment motor (M10). 2. Replace the finisher control PC board.
MJ-1024 (Front aligning plate motor abnormality) Is the front aligning plate home position sensor (PI36) normal? NO Replace the sensor. YES Is the wiring between the finisher controller PC board and the front aligning plate motor (M33) correct? NO Correct the wiring. YES Is there any mechanical problem with the path of aligning plate? NO Fix the mechanism. YES 1. Replace the front aligning plate motor. 2. Replace the finisher controller PC board.
MJ-1101 Is there any mechanical problem when the rear alignment plate is moved? ..YES Fix the mechanism. NO Is the harness between the rear alignment motor (M10) and the finisher control PC board (CN10) disconnected or open circuited? l ..YES • Reconnect the connector securely. • Replace the harness. NO 1. Replace the rear alignment motor (M10). 2. Replace the finisher control PC board.