Description: Stop jam at the exit sensor: The trailing edge of the original does not pass the exit sensor after its leading edge has reached this sensor.
Remedy: 1. Clean the exit roller if it is stained. 2. Is the exit/reverse sensor working? (Perform the input check: 03-[FAX]ON/[7]/[E]) * If it is working properly, proceed to 6. If not, check 3 to 5 below. 3. Check if the connector CN4 on the RADF board is disconnected from the exit/reverse sensor or the harnesses are open circuited. Correct if any. 4. Replace the exit/reverse sensor. 5. Replace the RADF board. 6. Replace the exit roller if it is worn out.