Code: EAC0
Description: Saddle transport delay jam: The paper which has reached the inlet sensor does not pass through this sensor. [MJ-1025/MJ-1024]
Remedy: MJ-1025 Is there any paper remaining on the paper transport path in the saddle stitcher section in the finisher? YES Remove the paper. NO Is the connector CN16 (folding position sensor) on the finisher controller PC board disconnected? Is the harness connecting the finisher controller PC board and folding position sensor opencircuited? YES Connect the connector securely. Replace the harness. NO Is the folding position sensor working properly? NO Replace the sensor. YES Replace the finisher controller PC board.
MJ-1024 1. Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the equipment. Remove it if there is. 2. Is the connector J21 on saddle stitcher controller PC board disconnected? 3. Is the harness between the saddle stitcher controller PC board and saddle inlet sensor [PI22] open circuited? 4. Is the saddle inlet sensor working properly? (Check the movement of the actuator.) 5. Replace the sensor. 6. Replace the saddle stitcher controller PC board.
MJ-1024 1. Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the equipment. Remove it if there is. 2. Is the connector J21 on saddle stitcher controller PC board disconnected? 3. Is the harness between the saddle stitcher controller PC board and saddle inlet sensor [PI22] open circuited? 4. Is the saddle inlet sensor working properly? (Check the movement of the actuator.) 5. Replace the sensor. 6. Replace the saddle stitcher controller PC board.