Code: C4E2
Description: Fuser belt rotation detection sensor abnormality - The fuser belt does not rotate or incorrectly rotates.
Causes: Fuser belt rotation detection sensor Detection plate (rotor) Dirty/damaged Fuser belt Deformed/damaged Bushing of fuser belt drive shaft Worn Bushing of fuser drive unit Worn Drive plate Bend section broken Gear Teeth damaged, worn LGC board
Remedy: Fuser unit • Fuser belt rotation detection sensor check (Input check: 03-[ALL]OFF/[6]/[A]) • Connector check in the fuser belt rotation sensor • Harness check in the fuser belt rotation sensor • Rotation detection plate (rotor) check • Grease check in the gear (shaft / tooth flank) • Fuser belt check • Check if the bushing of fuser belt drive shaft is worn. • Fuser unit installation check (Check that the levers fixing the fuser unit are lifted up.) Fuser drive unit • Bushing check • Check that the drive unit is correctly installed (3 dowels). • Check that the drive metal plate is not broken. • Check that the gear is not damaged or worn. • One-way clutch check • Grease check in the gear (shaft / tooth flank) LGC board • Connector check (CN355, CN356) • Board check