Description: ADU misfeeding (Paper not reaching the registration sensor): The paper which has passed through ADU does not reach the registration sensor during duplex printing
Causes: ADU clutch LGC board Rollers in the ADU
Remedy: 1 Open the ADU. Is there any paper in front of the registraton sensor? Yes Remove the paper. No 2 2 Is the registraton sensor working? (Perform the input check in the test mode: 03- [FAX]ON/[9]/[A]) Yes 3 No • Check if the connector of the 1st transport sensor is disconnected. • Check if the connector CN316 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the 1st registration sensor. • Replace the LGC board. 3 Is the ADU clutch working? (Perform the output check in the test mode: 03-222) Yes 4 No • Check if the connector of the ADU clutch is disconnected. • Check if the connector CN304 on the LGC board is disconnected. • Check if the connector pins are disconnected and the harnesses are open circuited. • Check if the conductor pattern on the LGC board is short circuited or open circuited. • Replace the ADU clutch. • Replace the LGC board. 4 Rollers in the ADU • Check the rollers in the ADU. Replace them if they are worn out.