Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi CBC0 — Toshiba e-Studio 456S

Code: CBC0

Description: Saddle Stitch Finisher side alignment motor (M15) abnormality: The alignment motor is not rotating or the alignment plate is not working properly. [MJ- 1106]
Causes: MJ-1106 Side alignment motor (M15) Saddle control PC board (SDL)
Remedy: MJ-1106 Saddle Unit If there is mechanical problem when the jog is moved, fix the mechanism. Side alignment motor (M15) Harness check Saddle control PC board (SDL) • Connector check (CN7) • Board check
MJ-1033 Saddle stitch alignment motor (M8) abnormality Check if the electrical continuity of the coil is normal. If electricity is not conducted, replace the motor. Saddle stitch alignment plate home position sensor (S20) abnormality Measure the voltage on pin CN16.12 on the finisher control PC board (FIN). Then check that the measured voltage is 1V or lower when not shielded and within the range of 3.3V±5% when shielded. If the voltage does not fall within the range mentioned, replace the sensor. Faulty cables and connectors Check if the electrical continuity between the connector terminals is normal. If electricity is not conducted, replace the connectors. (Finisher control PC board (FIN): CN6, CN16) Finisher control PC board (FIN) abnormality If the error still occurs after replacing the motor, sensor and connectors, exchange the finisher control PC board (FIN).

← Xem tất cả mã lỗi Toshiba e-Studio 456S

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie