Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E910 — Toshiba e-Studio 5005AC

Code: E910

Description: Paper not reaching the bridge unit transport sensor-1 jam
Causes: Bridge unit transport sensor-1 (entrance sensor) LGC board Bridge unit gate solenoid
Remedy: Paper separation failure at separation guide in the fuser unit Fuser unit • Check the gap between the separation guide and the fuser belt. "6.12.1 Adjustment of the Separation Guide Gap" • Paper tranceport check Drawer Check that paper is not skewed in the side guides of the drawer. Leading edge margin Adjust the margin with FS-05-4402 (Leading edge position adjustment) to "Color: 5.5 mm". Widen the margin if needed. (Specification Black: 4.2 mm / Color: 5 mm) • Use A3/LD paper • It is easy to check skew with a copy of a solid image (about 10 mm on its leading edge). Refer to ") • Connector check (CN307, J607, J801) • Harness check LGC board • Board check • Connector check (CN307) • Harness check Bridge unit • Does the transport roller of the bridge unit work when the fuser motor is rotated? (Perform the output check: FS-03-113/163) • Check the drive system of the equipment and bridge unit. • Check if the rollers in the lower exit roller, the pressure spring and the bridge unit are worn out.

← Xem tất cả mã lỗi Toshiba e-Studio 5005AC

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie