Code: EAB0
Description: [MJ-1110] Paper transport jam in the saddle stitch unit
Causes: Junction box paper detection sensor (S26) Feeding sensor (S22) Transport path-2 (S27) Transport path-3 (S28) Ejecting roller sensor (S29) Saddle transport motor (M16) Entrance motor (M1) Transport path switching solenoid (SOL5) Saddle control PC board (SDL) Finisher controller board (FIN)
Remedy: Paper • Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the equipment. Remove it if there is. • Use paper accepted in the specifications. Do not use the paper longer than the specification. Transport roller Fix any mechanical problem occurring when the transfer roller is rotated. Feeding sensor (S22) • Sensor check(S22) • Connector check (CN1) • Harness check Junction box paper detection sensor (S26) • Sensor check(S26) • Connector check(CN1) • Harness check Transport path-2 (S27) • Sensor check(S27) • Connector check(CN3) • Harness check Transport path-3 (S28) • Sensor check(S28) • Connector check(CN3) • Harness check Ejecting roller sensor(S29) • Sensor check(S29) • Connector check(CN3) • Harness check Saddle transport motor (M16) • Motor check(M16) • Connector check(CN5) • Harness check Transport path switching solenoid (SOL5) Check that the gap between the transfer guide surface and the upper surface of the flapper tip is in the acceptable range according to the status of the transport path switching solenoid (SOL5) (solenoid OFF: 1.5 to 2.1 mm, solenoid ON: 2.3 to 2.9 mm). If it is not, adjust it. Check if the harness between the transport path switching solenoid (SOL5) and the CN1 of the finisher controller PC board (FIN) is disconnected or open circuited. Correct if so. Entrance motor (M1) • Motor check(M1) • Connector check(CN17) • Harness check Harness Check if the flat cable between the finisher control PC board (FIN) and the saddle control PC board (SDL) is disconnected or open circuited. Correct if so. (Replace the harness if open circuited. Reconnect the connector securely if there is any disconnection.) Finisher control PC board (FIN) • Board check • Connector check(CN21) • Harness check Saddle control PC board (SDL) • Board check • Connector check(CN3, CN6) • Harness check