Code: C41
Description: Thermistor abnormal or heater disconnection at power ON
Remedy: Note) Before carrying out checks (1) and (2) below, first disconnect the power cord to prevent the danger of electric shock. (1) Check the thermistor. • Are the connectors disconnected? • Are the main and sub (end section) thermistors firmly contacting the heat roller? • Are the harness of the main and sub (end section) thermistors broken? (2) Check the heater lamp and SSR. • Is the heater lamp broken? • Is the heater lamp connector disconnected? • Is the thermostat blown? • Is the SSR connector disconnected? • Are the SSR and switching power supplies damaged? (3) Check the LGC board. • Is connector J326 disconnected? • Check the circuits for breaks, short-circuits or other troubles. • Replace the LGC board. (4) Reset the status counter. Carry out the following after you have repaired the location where error [C41] occurred: • Turn the power ON while holding the 0 and 8 keys down. • Enter “400” from the number key pad, and press the START key. • Overwrite currently displayed status counter 1 or 2 to 0, and press the SET or INTERRUPT key to cancel error [C41]. • Turn the power OFF then back ON, and check the machine enters a normal standby state.