Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E11 — Toshiba e-Studio 550

Code: E11

Description: Misfeeding during duplex printing (paper not reaching the registration sensor)
Remedy: Open the bypass unit cover. Is there any paper in front of the registration sensor? YES Remove the paper. NO Is the registration sensor working? (Perform the input check in the test mode:03-[ENERGY SAVER]ON/[4]/[E]) NO 1. Check if the connector of the registration sensor is disconnected. 2. Check if the connector J341 on the LGC board is disconnected. 3. Check if the connector pins are disconnected and the harnesses are open-circuited. 4. Check if the conductor pattern on the LGC board is short- or open-circuited. 5. Replace the registration sensor. 6. Replace the LGC board. YES Is the reversed paper transport cluch working? (Perform the output check in the test mode: 03-220, 221) NO 1. Check if the connector of the reversed paper transport clutch is disconnected. 2. Check if the connector J334 on the LGC board is disconnected. 3. Check if the connector pins are disconnected and the harnesses are open-circuited. 4. Check if the conductor pattern on the LGC board is short- or open-circuited. 5. Replace the reversed paper transport clutch. 6. Replace the LGC board. YES Check the rollers in the reversed papaer transport section. Replace them if they are worn out.

← Xem tất cả mã lỗi Toshiba e-Studio 550

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie