Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E52 — Toshiba e-Studio 550

Code: E52

Description: Leading edge of paper not reaching the transport sensor 2
Remedy: Is there any paper at the reverse section when the exit cover is opened? Remove the paper. Is the transport sensor 2 working? (Perform the input check in the test mode: 03-[ENERGY SAVER]OFF/[9]/[B]) 1. Check if the connector of the transport sensor 2 is not disconnected. 2. Check if the connector J334 on the LGC board is not disconnected. 3. Check if the connector pins are not disconnected and the harness is not open-circuited. 4. Check if the conductor pattern on the LGC board is not short- or opencircuited. 5. Replace the transport sensor 2. 6. Replace the LGC board. Is the transport roller at the horizontal transport section rotating? (Perform the output check in the test mode: 03-113/110/220) 1. Check if the drawer connector is not disconnected. 2. Check if the connectors of the transport drive clutch and transport clutch 2 are not disconnected. 3. Check if the connectors of the transport drive clutch and transport clutch 2 are not misconnected (drive clutch: black-black, transport clutch 2: black-blue). 4. Check if the connector J334 on the LGC board is not disconnected. 5. Check if the connector pins are not disconnected and the harness is not open-circuited. 6. Check if the conductor pattern on the LGC board is not short- or opencircuited. 7. Replace the transport drive clutch and transport clutch 2. 8. Replace the LGC board. 9. Check if the front side timing belt is put on properly. Check the condition of the roller at the horizontal transport section and clean it, or if it is deteriorated, replace it.

← Xem tất cả mã lỗi Toshiba e-Studio 550

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie