Code: E130
Description: 1st drawer misfeeding (Paper not reaching the 1st drawer feed sensor): The paper fed from the 1st drawer does not reach the 1st drawer feed sensor.
Remedy: 1. Open the jam access cover and check if there is any paper in front of the 1st drawer feed sensor. Remove it if there is. * If the error still occurs, check the following. 2. Is the 1st drawer feed sensor working? (Perform the input check: 03-[FAX]ON/[1]/[G]) * If it is working properly, proceed to 9. If not, check 3 to 8 below. 3. Check if the connector CN513 on the PFC board is disconnected from the 1st drawer feed sensor or the harnesses are open circuited. Correct if any. 4. Replace the 1st drawer feed sensor. 5. Replace the PFC board. 6. Is the feed motor working? (Perform the output check: 03-120) * If it is working properly, proceed to 10. If not, check 7 to 9 below. 7. Check if the connector CN512 on the PFC board is disconnected from the feed motor or the harnesses are open circuited. Correct if any. 8. Replace the feed motor. 9. Replace the PFC board. 10.Check the 1st drawer feed roller, separation roller and pickup roller. Replace them if they are worn out.