Description: Paper transport delay jam: The paper which has passed the relay transport path does not reach the inlet sensor. [MJ-1103/1104]
Remedy: 1. Check if there is any paper in the finisher or on the transport path of the equipment and remove it if there is. 2. Is there a disconnection of the connector, incorrect installation or breakage of the entrance sensor (S1)? 3. Is the gap between the flapper and entrance roller shaft other than 0.60 - 0.20mm when the gate solenoid (SOL2) is pulled?. 4. Is the harness between the entrance motor (M1) and the finisher control PC board (CN7) disconnected or open circuited? 5. Is the harness between the gate solenoid (SOL2) and the finisher control PC board (CN22) disconnected or open circuited? 6. Replace the finisher controller PC board.