Code: E230
Description: 1st drawer misfeeding (Paper not reaching the 1st drawer transport sensor): Paper fed from the 1st drawer does not reach the 1st drawer transport sensor.
Remedy: 1. Is the 1st drawer transport sensor working? (Perform the input check: 03-[SCAN]ON/[1]/[D]). * If it is working properly, proceed to 6. If not, check 2 to 5 below. 2. Check if the connector CN513 on the PFC board is disconnected from the 1st drawer transport sensor or the harnesses are open circuited. Correct if so. 3. Check if the 1st drawer transport sensor is correctly installed or the actuator is properly moved. 4. Replace the 1st drawer transport sensor. 5. Replace the PFC board. 6. Are the transport motor-1 and the feed motor working properly? (Perform the output check: 03- 124, 03-120.) * If they are working properly, proceed to 10. If not, check 7 to 9 below. 7. Check if the connector CN512 on the PFC board is disconnected from the transport motor-1 or the feed motor, or the harnesses are open circuited. Correct if so. 8. Replace the transport motor-1 or the feed motor. 9. Replace the PFC board. 10.Check if there is any abnormality on the driving section of each motor or the roller. Correct if any.