Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi E011 — Toshiba e-Studio 5540c

Code: E011

Description: Transfer belt paper-clinging jam: The paper after the 2nd transfer is clinging to the transfer belt, or a paper jam occurred between the registration roller and the paper clinging detection sensor.
Causes: Paper clinging detection sensor Registration motor PFC board LGC board Rollers
Remedy: Paper clinging detection sensor • Sensor check (Perform the input check: 03-[ALL]OFF/[9]/[D]) • Connector check • Harness check Registration motor • Motor check (Perform the output check: 03-128/528) • Connector check • Harness check PFC board • Connector check (CN514, CN515) • Board check LGC board • Connector check (CN537, CN538, CN539) • Board check Drive unit, Rollers • Gear check • Roller check Setting If jams occur on the back side in duplex printing, change the media type mode to the recycled paper mode, and then check if there are still jams. (When this type of jam occurs on heavily curled paper during duplex printing, the jam may be resolved by selecting the recycled paper mode.) 2nd transfer bias offset Change the 2nd transfer bias offset value as shown below and then check if there are still jams. Change the default value 5 of each code below to 6 or 7. Color: 05-2934 Subcode: 0, 7 Color: 05-2935 Subcode: 0, 7 Black: 05-2936 Subcode: 0, 7 Black: 05-2937 Subcode: 0, 7 Change of the 2nd transfer bias If the leading edge of paper clings to the 2nd transfer roller and causes paper jamming, change the 2nd transfer roller bias correction factor of the leading/trailing edge of the paper. (The larger the value, the smaller the transfer voltage of the leading/trailing edge of the paper.) Codes to be changed (Initial value of the transfer bias of the leading/trailing edge of the paper: 0) • Color mode print (top side): 05-2938-* • Color mode print (back side): 05-2939-* • Black mode print (top side): 05-2940-* • Black mode print (back side): 05-2941-* Sub codes:* → Plain paper: 0, Recycled paper: 7 Notes: After these codes are changed, perform solid duplexprinting and check that there is no faint or void image on the leading/trailing edge of the paper. Other Check if there is any paper clinging to the transfer belt or entering under the receiving tray. Remove it if there is. Use the paper within the specification if the thin paper being used is out of specification.

← Xem tất cả mã lỗi Toshiba e-Studio 5540c

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie